ENVIRONMENTAL EDUCATION SERIES ENVIRONMENTAL QUALITY Agriculture & Natural Resources
EXTENSION ENVIRONMENTAL EDUCATION, AUBURN UNIVERSITY, AL 36849-5647

A barren area in the grass where a sprayer has been cleaned is an indication of a poor sprayer cleanup program. If the sprayer is cleaned in the same place year after year, the soil bacteria that normally break down chemicals are killed. This allows the chemical concentration to build up. Ultimately, these chemical residues can find their way into the water table.

The presence of chemicals in groundwater is a major concern. Farmers are subject to the same EPA regulations as custom applicators and commercial suppliers. Consequently, farmers are liable for the massive cleanup costs that might result from improper disposal of chemical wastes.

EPA regulations generally say that when spraying hazardous chemicals, water used to rinse the inside of the spray tanks or plumbing is hazardous waste. Even the material washed off the outside of the sprayer is classified as hazardous. Options for disposing of hazardous waste include reusing it, bottling it up and taking it to a hazardous waste disposal site, or running it through a charcoal filtration system. The only practical method for farmers is to reuse the material, applying it at label rates.

Reuse, however, is not as simple as it sounds. It requires a system to catch and contain the unused chemical and rinsate until it can be applied. The diagrams below illustrate these types of systems. They consist of a concrete loading and mixing pad of liquid nitrogen storage. Also, a roof construction over the loading and mixing area is desirable for the southeast. If a roof is not used, then washing the pad area after each use is a must. A one inch rain on a 20 feet by 30 feet concrete pad results in 328 gallons of water. If the pad area was contaminated, then the 328 gallons would be hazardous waste.

An alternative to the concrete loading and mixing area is to mix and load in the field. Have at the field site a nurse tank for water to fill the sprayer tank, and add chemicals as needed. This will eliminate any build up of residue from rinsate being deposited on one site. When spraying from the last tank, mix only the amount required to finish spraying the field. Finish by adding at least 10 percent by volume of water to the emptied tank, and spray this material back over the field or the field borders. Exterior washing should be conducted at the same time. This will leave the residue in the field of pesticide destination.

Community Resource Development homepage | CRD Publications