Farm and Livestock

ACES-2275
RECOVERY

Flooded Farm Vehicles and Equipment

Tips on Cleaning and Reconditioning

Check your insurance requirements first before operating or attempting to clean vehicles, equipment, or tractors. File appropriate claims. Then clean tractors, trucks, and farm equipment. Delay makes dirt and silt harder to remove and may cause considerable rusting and corrosion. If you use farm vehicles and equipment before proper reconditioning, you may seriously damage them.

Have your dealer or another expert recondition engines. Do not try to move or start an engine that has been underwater until the engine has been cleaned and reconditioned. Dirt will damage bearings and precision parts. Clean and service all equipment, with special attention to parts that were below water level. If saltwater flooded the equipment, wash with fresh water.

Emergency Cleaning

If you must use the tractor or engine immediately, or if you think the cost of professional reconditioning is not worthwhile, use the following procedure. This procedure is not thorough enough, however, to prevent possible damage or need for overhaul in the future.

  • Clean exterior thoroughly with fresh water/soapy water and a pressure washer. Scrub greasy deposits with solvent.
  • Remove spark plugs or fuel injectors, air cleaner, intake manifold, and carburetor. Clean these parts thoroughly with solvent. Discard and replace water-soaked paper air filters.
  • Operate the engine slowly without an air filter.
  • Drain the crankcase. Flush the crankcase and refill. Also disconnect gasoline lines, blowing them out with compressed air. Do not disconnect diesel lines. Inspect diesel fuel system to see if water is present in the tank and filters. If water is present, have trained service personnel clean the fuel system.
  • Crank the engine slowly with spark plugs or fuel injectors removed to force water out of cylinders. Squirt light lubricating oil into each cylinder, and let it stand for about 5 minutes. Then crank the engine slowly to lubricate cylinder walls and rings.
  • Replace all filters–engines, fuel, and hydraulic.
  • Completely flush out the fuel system–tank, pump, and lines. Be extremely careful to avoid fire danger.
  • Clean starter and generator or alternator. Have an expert service them.
  • Drain and flush the transmission and final drive with solvent. Refill with new, clean oil. Check for water in oil compartments by loosening drain plugs until all water drains out.

Wheel Bearings, Cooling Systems, and Batteries

  • Remove and clean unsealed wheel and track bearings with solvent. Lubricate and replace the bearings.
  • Factory-sealed bearings should not need cleaning if the seal is unbroken.
  • Clean all debris from the radiator, and wash with soapy water. Most cooling systems are sealed and would not need flushing, but you should change or flush and replace with a new antifreeze.
  • Replace the battery, if necessary. If it was submerged, it will probably need to be replaced.

Used by permission of the Mississippi State University Extension Service.


This document is part of a larger publication titled Emergency Handbook: Preparation and Recovery (ACES-2168).

The Emergency Handbook is available digitally as an iBook and on the web. Use the left-hand navigation bar to access all topics and pages. This publication is not available in print. To download or print the pages you need, please look for Printable PDF Download this information.


For more information, contact your county Extension office.